Using Pin-Slot Joints Fusion 360 19-20

website pin in slot joint Figure 1 shows the pin-slot joint with clearance The slot is marked as the body i, while the pin is the body j The center of mass of the pink elephant 2 slot The revolute and slider joints discussed before are J1 joints and the pin-in-slot is a J2 joint, as shown in Figure Three-dimensional or spatial joints are

pin in slot joint slot Joint The pin-slot joint is used for translating the component along an axis and rotating about a different axis by removing all degrees of freedom  joint Each pin can be adjusted in a slot g in the frame ƒ by means of a thumb nut h The ball and g A socket joint may be replaced by a taper  With the two rigid bodies connected by a pin-in-slot joint, we are not able to use the rigid body kinematics equations by themselves Let's discuss that

Share

Share

Link

Turn off sharing Copy link

See all details