Buy T-Track & Mitre Track

0:07 I used a steel ruler to mark two parallel lines on either side of the blade From these marks I measured and drew two the mitre slot lines 0:48 After

When I make runners for a jig, either using wood or some man made stuff , I rip them with a slight bevel on the edges,but not out

how to hack slot machines with phone 2023 slot, so jigs remain reliably square to the cutter Once set, the low-friction runners slide freely in any standard 34 wide by 38 deep miter slot Each

holy789 slot With this t track slider bar you can custom build your own jigs and fixtures for use in industry standard mitre slots or 19mm T track