fret slot depth
Fret Slot Depth Gauge
Fret Slot Depth Gauge
Fret Slot Depth Gauge fret slot depth fret slot depths again after creating the fretboard radius, this is easier done after the neck is fret slot saw The laser-cut Acrylic depth stop should be adjusted to cut a slot that is just slightly deeper than the tang of the frets Fret slots which are too deep weaken
fret slot saw Ideally the slot should end up 1o-20% deeper than the fret tang - the small gap underneath is filled usually with superglue Good luck
fret slot width pop one in a stewmac mini router base with a dremel or foredom, carefully set the depth and carefully run it through the fret slot and you'll You never want the slot too shallow, that's for sure Still, most companies cut deep slots to account for leveling, inlays & sanding, different